Wieland samos PRO, Manual

Page: 113 / 192

PROFIBUS DP gateway
Wieland Electric GmbH | BA000970 | 07/2019 [9855]
113
The content of the data blocks can be freely selected, but has been preconfigured as follows in the
samosPLAN 6:
Table 77: Predefined content of input data block 1–5 of the SP-PROFIBUS-DP module
Data block 1 Data block 2 Data block 3 Data block 4 Data block 5
Output data block Output data block Output data block Output data block Output data block
Byte 0
Input values for
Module 0 (I1..I8) Input values for
Module 1 Output values for
Module 1 Not allocated Not allocated
Byte 1 Input values for
Module 0 (I9..I16) Input values for
Module 2 Output values for
Module 2
Not allocated Not allocated
Byte 2 Input values for
Module 0 (IQ1..IQ4) Input values for
Module 3 Output values for
Module 3 Not allocated Not available
Byte 3 Output values for
Module 0
(Q1..Q4,IQ1-IQ4) Input values for
Module 4 Output values for
Module 4 Not allocated
Byte 4
Direct data
(Off) 0 Input values for
Module 5 Output values for
Module 5 Not allocated
Byte 5 Direct data
(Off) 1 Input values for
Module 6 Output values for
Module 6
Not allocated
Byte 6 Direct data
(Off) 2 Input values for
Module 7 Output values for
Module 7 Not allocated
Byte 7
Direct data
(Off) 3 Input values for
Module 8 Output values for
Module 8 Not allocated
Byte 8
Direct data
(Off) 4 Input values for
Module 9 Output values for
Module 9 Not allocated
Byte 9
Direct data
(Off) 5 Input values for
Module 10 Output values for
Module 10 Not allocated
Byte 10 Direct data
(Off) 6
Input values for
Module 11 Output values for
Module 11 Not allocated
Byte 11 Direct data
(Off) 7
Input values for
Module 12 Output values for
Module 12 Not allocated
Length
12 bytes 12 bytes 12 bytes 12 bytes 2 bytes
Start
address
1 13 25 37 49
Detailed information about the content of the process diagram may be found here: Data transferred
to the network (network input data sets [ch. 3.2, p. 19] ).
Delete any bytes not required
You can delete bytes pre-allocated by samosPLAN 6 that you do not require by clicking on them with
the mouse.

Launch samosPLAN 6.

Read in the hardware configuration, including the PROFIBUS-DP gateway.
Instructions: Software manual, chapter "Connecting to the safety controller"
 Switch to the
Gateway
view.
 Click on the byte you do not need and wish to delete.
 Click on the
Delete
icon in the command bar.
You will find further information about how to configure the process diagram here: