Waygate Technologies Krautkramer USM Go, Operating Manual

Page: 156 / 296

5 Operation General setup
5-80 Rev. 10 (06/2021) USM Go
TOF in LAYER
As an alternative to the display of an exact value (time-
of-flight or distance), the USM Go can only display the
layer in which a reflector is located.
You can specify layers of varying depth (but with identi-
cal material velocity) for this purpose. They are auto-
matically numbered consecutively. With the function
TOF in LAYER turned on, only the number of the layer
is displayed in which the flaw (e.g. inclusion or separa-
tion) is located.
Defining layers
You can define either the thickness of a single layer or
the thicknesses of 10 layers within a range of
1.00 … 10.0 mm each.
– Switch to the second operating level.
– Select the function group CONFIG3 .
– Select the function TOF in LAYER and press a func-
tion key to turn on the function.
– Switch to the function LAYER TYPE and press the
function keys to choose the mode for a single layer
(
STANDARD ) or for 10 layers ( CUSTOM ).
– Switch to the function LAYER EDIT and briefly press
the joystick (USM Go) or the center key of the keypad
(USM Go+) to set one or several layer thicknesses.
The list of layers with the corresponding thicknesses
in each case is displayed.
– Use the navigation or the function keys to set the re-
quired values.