WAGNER TITANIUS TOP-SENS, Technical Manual

Page: 139 / 250

TITANUS
TOP·SENS
®
/Rev.a
Installation
06/13 139
2. Open the required, pre-stamped cable feeds (max. 8 x M20 and 6 x
M25) in the housing. If necessary, use a screwdriver to help.
3. Attach M20 or M25 cable guides to the opened cable feeds. Then press
the cable guides into the corresponding opening.
4. For the cabling, route the connection cable(s) (max. 1.5 mm
2
) through
the housing's prepared cable guide(s).
5. Connect the battery and insert the memory card into the network module
(only included with types NU-5-D, -DO,-D-F, -DO-F).
6. Connect the network module as indicated in the circuit diagram.
WARNING
All network cards are assigned the same IP address by the manufacturer. It
is necessary to ensure that the standard IP address (192.168.1.5) has not
been allocated in the network as this can otherwise cause network interfer-
ence.
7. Mount the network module only in the designated position in the TITA-
NUS
®
housing.
8. Once the network module is successfully installed, reconnect the display
board to the main board.
9. Close the housing cover.
10. Reconnect the voltage supply.
Connecting the network module
The network module connects the network to the TITANUS
®
. The electrical
connection required for the air sampling smoke detection system circuit
board is illustrated below.
NOTICE
The network may only be set up in consultation with the customer's system
administrator(s).
6.8.2