Wacker Neuson BS 50-4s, BS 50-4As, Repair Manual

Page: 67 / 194

wc_tx004029gb_FM10.fm
67
Rammer Disassembly and Reassembly
Continued from the previous page.
5. Drive out the two end plugs (n) and the piston pin (o) that holds the connecting
rod to the ram (c) .
Note: Do not reuse the end plugs.
6. With the aid of an assistant, lift and remove the crankcase from the ramming
system.
7. Remove the O-ring (f) from the ramming system .
Note: Do not reuse the O-ring.
8. Loosen the upper clamp (h) .
9. Stand on the ramming shoe and pull the guide cylinder (e) from the bellows (j) .
10.Loosen the lower clamp (k) .
11.Stand on the ramming shoe and tap along the bottom of the bellows with a
rubber mallet until the bellows (j) are removed from the protective pipe (m) .
Result The bellows have now been removed.
wc_gr012840
n
o
n
e
m
f
a
j
k
c
h