Vonage V-Portal User Guide
IP Filtering allows you to block access to the Internet based on a specific IP address. You can
specify a single IP address or a range of IP addresses. Although not required, we recommend
that IP Filtering be used on Local Area Networks that use Static IP Addresses. With DHCP (i.e. IP
addresses that change), you would need to re-configure your IP Filtering settings every time your
devices received new IP Addresses. This will happen every time a device is rebooted or if there is
a power outage.
Setting Up IP Filtering
To setup IP Filtering:
From the home page, click on the Advanced Setup tab. Click on the Filtering sub-menu. The IP
Filtering section is at the top of that screen:
To restrict access to the Internet based on a device’s IP Address:
•
Enter
the
Start Address
ess for a single device, the End IP
ts of
•
Enter
the
End Address. If you are only restricting acc
me as the Start IP address.
address will be the sa
NOTE: You only need to enter the last part (octet) of the IP address. The other 3 octe
the IP address are automatically filled in for you.
•
Check
the
Enabled box
button.
•
Click
the
Apply
These steps can be repeated for additional devices.
To remove restricted access to the Internet previously configured:
x next to the IP address of the device you want to restore
•
Uncheck
the
Enabled bo
access for
•
Click
the
Apply button.
MAC Filtering
View the Terms of Service by visiting the Vonage website at www.vonage.com/tos. Pay particular attention to
Section 11 which explains limitations on Warranty, Remedy and Liability.
61