Vonage V-Portal User Guide
To setup your Static IP connection:
•
Enter the following information obtained from your ISP:
o
IP
Address
o
Subnet
Mask
o
Default
Gateway
o
Primary
DNS
o
Secondary
DNS
e
tton.
•
The V-Portal will restart. (You don’t have to do anything, except please be patient and
wait until the V-Portal completes its startup sequence. The
V-Portal is ready to make calls when you see the phone icon.
•
Enter
the
MTU Size**(optional). If no value is entered, the default value will be used. W
recommend using the default value unless your ISP or Vonage Customer Care has
asked you to change it.
•
Click
the
Apply bu
)
**MTU stands for Maximum Transmission Unit. This indicates the largest packet that can be
transmitted across the network. By default, the MTU Size parameter in the V-Portal is set to 0
which indicates a value of 1492 will be used. Adjusting the MTU size is helpful in rare scenarios
where some upstream device is unable to accept larger size packets and consequently it drops
packets from the V-Portal. We recommend using the default value unle s your ISP or Vonage
ustomer Care has asked you to change it. Please check with your ISP for the MTU setting used
on their network.
s
C
View the Terms of Service by visiting the Vonage website at www.vonage.com/tos. Pay particular attention to
Section 11 which explains limitations on Warranty, Remedy and Liability.
46