Vodavi STARPLUS Triad XTS, Installation Manual

Page: 126 / 138

4-24 VOIP Maintenance and Troubleshooting
Chapter 4 - Maintenance and Troubleshooting
The following command options and system prompt will display:
5. Type s and press <Enter> to enable bank switching.
The following message will display:
6. To use the newly loaded software, power the XTS system Off or On, whichever applies.
VOIP Maintenance and Troubleshooting
VoIP Administrative Functions
These functions are accessible through an RS-232 connection via the ADMIN port located on
the VoIP card. Configurations and tracing VoIP card events can be viewed from this console
connection. No programming can be performed, but firmware upgrades can be done through
the admin port.
Locating the VoIP Card through the MPB
1. Attach a straight-through cable to the MPB (RS-232) @ 19.2K.
2. When prompted for a password, type
config .
3. Type d s at the maint > prompt to view the location of the VoIP card.
Figure 4-9: VoIP Card Location Printout
The “s” command is used as a toggle. Therefore, if bank switching is enabled,
type
s , and then press <Enter> to disable.
ENTER PASSWORD: config
maint>d s
SLOT BRD TYPE SERV STAT BRD OPTS FW VER.
--------- ---------- ----------- ---------- ---------
00 DT24 INS 0 00-0
01 DT24 OOS
04 VOIP INS 0 01A-7
COMMAND DESCRIPTION
____________________
b
show baud rate
d download software using zmodem
s bank switching
u upload software using zmodem
x Ex i t
? or h Help, Guide
maint>swupdown>
Bank switching is enabled...
Please, make a reset to initiate switching banks...