Vodavi Starplus DHS, Technical Manual

Page: 237 / 338

5-10 Flash
Flash
Description
This feature allows CO/PBX line users working behind a Centrex or PBX line to generate a
hook-flash over that line to access features or transfer calls.
Operation
While connected to a CO/PBX line:
1. Press flash
2. Dial [#] + [3]
Hold
Flash
Description
CO line calls and ICM calls may be placed on Hold.
Operation
While connected to a CO Line:
1. Press Hook Flash
2. After a 5 second delay, dial tone is heard, and the party is placed on hold.
3. Hang up
While connected to an intercom call:
1. Press Hook Flash
2. Dial tone is heard, and the party is placed on hold.
3. Hang up
Conditions
†
When an intercom/CO line call is placed on Hold and the holding party hangs up,
after the Hold Reminder time is elapsed, the system will ring the hold activating
station with internal or external ring signal. If Hold Reminder is disabled, 30 seconds
after the call is placed on hold, the system will give the holding party recall ring
(internal ring for held ICM call and external ring for held CO Line call). Refer to
Chapter
4, Keystation Features and Operation, “Reminder Time” .
†
If Call Abandon is set and properly functioning, calls placed on hold will be released if
the outside party disconnects.
It is recommended that SLT stations installed be equipped with a TAP or FLASH button and
the guaranteed disconnect feature. (Many SLT models offer these features.) These features
will greatly enhance.If the SLT station user stays on-hook for any time exceeding the END
time programmed, the previous call will be disconnected.