Chapter 20 Remote Management
EMG2926-Q10A User’s Guide
142
Figure 103
Management > Remote Management > SNMP
The following table describes the labels on this screen.
Table 67
Management > Remote Management > SNMP
LABEL
DESCRIPTION
SNMP Settings
Server Port
You may change the server port number for a service if needed. However, you must
use the same port number in order to use the service for remote management.
Server Access
Select the interface(s) through which a computer may access the EMG2926-Q10A
using the service.
Secured IP
Select
All
to allow all computers to access the EMG2926-Q10A.
Otherwise, check
Selected
and specify the IP address of the computer that can
access the EMG2926-Q10A.
SNMP Enable
Select this to allow a manager station to manage and monitor the EMG2926-Q10A
through the network via SNMP.
Get Community
Enter the password for the incoming Get and GetNext requests from the
management station. The default is public and allows all requests.
Set Community
Enter the password for incoming Set requests from the management station. The
default is public and allows all requests.
System Location
Specify the geographic location of the EMG2926-Q10A.
System Contact
Enter the name of the person in charge of the EMG2926-Q10A.
Trap Settings
Trap Enable
Select this to have the EMG2926-Q10A send an SNMP trap to the specified IP
address when it receives the event. Deselect to disable this feature.
Trap Manager IP
Type the IP address of the SNMP manager to which your SNMP traps are sent.
