Chapter 10 LAN
EMG2926-Q10A User’s Guide
99
10.4 IPv6 LAN Screen
Use this screen to configure the IPv6 address for your EMG2926-Q10A on the LAN. Click
Network
> LAN > IPv6 LAN
.
Figure 69
Network > LAN > IPv6 LAN
The following table describes the labels on this screen.
Apply
Click
Apply
to save your changes to the EMG2926-Q10A.
Cancel
Click
Cancel
to begin configuring this screen afresh.
Table 44
Network > LAN > IP Alias (continued)
LABEL
DESCRIPTION
Table 45
Network > LAN > IPv6 LAN
LABEL
DESCRIPTION
Minimum RA period Enter the minimum time in seconds between router advertisement messages.
Router advertisement (RA) is a response to a router solicitation or to a periodical
multicast advertisement from a router to advertise its presence and other parameters.
The router in router advertisements can be used as a default router.
Enable DHCPv6-PD
Select this option to use DHCPv6 prefix delegation. The EMG2926-Q10A will obtain an
IPv6 prefix from the ISP or a connected uplink router for the LAN.
Autoconfigurati
on Type
Select
SLAAC
(Stateless Address Autoconfiguration)
+ RDNSS
(Recursive DNS Server)
to enable IPv6 stateless autoconfiguration on this interface. The interface will generate
an IPv6 address from a prefix obtained from an IPv6 router in the network.
Select
SLAAC + Stateless DHCPv6
to enable IPv6 stateless auto-configuration on this
interface. The interface will get an IPv6 address from an IPv6 router. Hosts use DHCPv6
to obtain additional configuration settings, such as DNS information.
Select
Stateful DHCPv6
to allow a DHCPv6 server to assign and transfer IPv6 network
addresses, prefixes and other configuration information to DHCPv6 clients.
IPv6 Address
range(Start)
If you select
Stateful DHCPv6
, specify the range of IPv6 addresses from which the
DHCPv6 server assigns to the clients. Enter the smallest value of the last block of IPv6
addresses to be allocated.
