Chapter 1 Introduction
EMG2926-Q10A User’s Guide
16
1.8 Wall Mounting
You may need screw anchors if mounting on a concrete or brick wall.
1
Select a position free of obstructions on a wall strong enough to hold the weight of the device.
2
Mark two holes on the wall at the appropriate distance apart for the screws.
Be careful to avoid damaging pipes or cables located inside the wall
when drilling holes for the screws.
3
If using screw anchors, drill two holes for the screw anchors into the wall. Push the anchors into the
full depth of the holes, then insert the screws into the anchors. Do not insert the screws all the way
in - leave a gap of about 0.5 cm.
If not using screw anchors, use a screwdriver to insert the screws into the wall. Do not insert the
screws all the way in - leave a gap of about 0.5 cm.
4
Make sure the screws are fastened well enough to hold the weight of the EMG2926-Q10A with the
connection cables.
5
Align the holes on the back of the EMG2926-Q10A with the screws on the wall. Hang the EMG2926-
Q10A on the screws.
WLAN 2.4/5G
On
The EMG2926-Q10A is ready, but is not sending/receiving data through the
5G wireless LAN.
Blinking
The EMG2926-Q10A is sending/receiving data through the 5G wireless LAN.
The EMG2926-Q10A is negotiating a WPS connection with a wireless client.
Off
The wireless LAN is not ready or has failed.
LAN 1-4
On
The EMG2926-Q10A’s LAN connection is ready.
Blinking
The EMG2926-Q10A is sending/receiving data through the LAN at a
1000Mbps transmission rate.
Off
The LAN connection is not ready, or has failed.
USB 1-2
On
The EMG2926-Q10A has a USB device installed.
Blinking
The EMG2926-Q10A is transmitting and/or receiving data from routers
through an installed USB device.
Off
There is no USB device connected to the EMG2926-Q10A.
Table 1
Front Panel LEDs and WPS Button (continued)
LED
STATUS
DESCRIPTION
Table 2
Wall Mounting Information
Distance between holes
12.7 cm
M4 screws
Two
Screw anchors (optional)
Two
