To be done before spreading
56
Online spreading chart
service
Information about the settings for the spreader can be found in the
spreading chart book, as well as on the online spreading chart service.
This will also provide information about additional types of fertiliser
that have been tested recently.
You can make use of the online spreading chart service as an
alternative to the spreading chart book. You must enter the character-
istics of the fertiliser, your working width, application rate, driving
speed and the type of fertiliser. You will then receive advice from the
website for setting your spreader: dosing setting, discharge point,
flowrate, angle of the spreader and the vane combination.
Methods for adjusting the spreader can be found at:
→
chapter »Setting the spreader« on page 57.
Also check the advice given on the online spreading chart service. Do
a calibration test to check the dosing setting. Then check the
spreading pattern with a tray test.
→
See paragraph »Calibration test« on page 75 and
→
paragraph »Check the spreading pattern (tray test)« on page 80.
You can reach the spreading chart service as follows:
Go to the website of the Kverneland Group:
http://www.Kvernelandgroup.com.
The various marks are given at the top of the page. Select
Vicon
.
The
Vicon
page is on the left of the
Vicon
menu. Click on the
Spreading Charts
link.
The
Links & Attachments
menu is given on the right of this page.
Select here the link to the spreading chart in your preferred
language.
Start the spreading chart service and complete the details
required.
The spreading chart service will then request that you select a
product with comparable characteristics.
The spreading chart service will then indicate the settings for your
spreader. Follow the working methods as described in
→
paragraph »Setting the spreader« on page 57.
Summary of Contents for RO-C 1400
Page 4: ...Table of contents 4...
Page 139: ...Maintenance 139 109 mm Rope Discharge bushing Position V Mechanical...
Page 153: ...Notes 153 Notes...
