Before first use
44
Setting the safety clutch
There is a safety clutch on the machine side of the coupling shaft. This
safety clutch protects the machine against overloading.
First check the setting of the pressure springs in the safety clutch.
The spring length must be 26 mm.
A static calibration test can be performed with a torque wrench.
Set the torque wrench to 400 Nm.
Friction should occur as soon as it is turned.
T
IP
It is possible that the coupling should be “broken out” at a higher
torque for the first time.
Always mount the check chains of the protection sleeves
The check chains prevent the protection sleeves from rotating with the
coupling shaft. Crop or pieces of clothing can be wound around
rotating protection sleeves and cause material damage and possibly
severe physical injury.
Mount the check chains to both outer edges of the coupling shaft
protective sleeves.
Mount the other ends of the chains to a fixed point of the tractor,
respectively the machine.
Summary of Contents for RO-C 1400
Page 4: ...Table of contents 4...
Page 139: ...Maintenance 139 109 mm Rope Discharge bushing Position V Mechanical...
Page 153: ...Notes 153 Notes...
