To be done before spreading
92
Testing the spreading
pattern with the tramline
cylinder
When using the tramline cylinder the aim is to obtain maximum
distribution to the border with minimum loss in the ditch.
This is then why the tramline cylinder has to be tested. Do not perform
this test next to the ditch, rather mark a line behind which the fictive
ditch will be.
I
NDICATION
Always perform a calibration test first and determine the correct
dosing setting before checking the spreading pattern. Changes to the
dosing setting will also have an influence on the spreading pattern!
→
See paragraph »Calibration test« on page 75.
Operation
Run the hydraulic control valve for a few seconds to activate the
tramline cylinder.
Set the spreader in accordance with the spreading chart for the
desired working width
(height of the spreading disc = 75
cm
above the troughs) and the instructions given in
→
paragraph »Border spreading with the tramline cylinder« on
page 111.
Switch the tractor off, remove the key from the ignition and engage
the parking brake of the tractor.
Place 1 trough on the land next to the fictive border ditch and 1
trough next to each other in the fictive ditch.
I
NDICATION
Position the troughs horizontally with a spirit level!
Place 1 trough in the middle of the tractor tracks. The driving track
must be half a working width from the fictive ditch. Divide the
additional buckets between the track and the fictive ditch.
½X m
(½X ft)
X/10 m (ft)
X/10 m (ft) X/10 m (ft)
X/10 m (ft)
X/10 m (ft)
tramline cylinder
Summary of Contents for RO-C 1400
Page 4: ...Table of contents 4...
Page 139: ...Maintenance 139 109 mm Rope Discharge bushing Position V Mechanical...
Page 153: ...Notes 153 Notes...
