ViaSat SurfBeam 2, Operation Manual

Page: 15 / 66

SurfBeam® 2 Pro Portable Terminal Operations Guide
© 2014 ViaSat, Inc.
Page 2-8
All Rights Reserved
1172964, Rev. 002 ViaSat Proprietary Information
Step Action Image
11. Turn the Elevation lever until tightened (leaving the Elevation
knob loose).
12. Loosen Assembly Post knob.
13.
Slide the Assembly onto the Tripod’s post and rotate it to ensure
proper seating (revealing a 1/4-inch gap between the Assembly’s
collar bottom and the top of the Tripod’s legs).
14. Tighten the Assembly Post knob.
15. Loosening/tightening the knobs on the Tripod’s legs and using
the leveling bubble on the Assembly base-plate, make the
appropriate adjustments to get the leveling bubble to show
inside the black circle.
NOTE : It is not necessary to get the bubble to lineup exactly
within the back circle. Approximately 90% or more of the bubble
within the circle should be enough.
16. Remove the Assembly, go to the transit case, and fold open the
two pockets that held the Assembly and Tripod to gain access to
the Center Reflector.