SurfBeam® 2 Pro Portable Terminal Operations Guide
© 2014 ViaSat, Inc.
Page 2-11
All Rights Reserved
ViaSat Proprietary Information
Step
Action
Image
29.
Attach the modem assembly to the Tripod leg pointing north and
insert the quick-release pin (pressing the pin’s blue button)
through the assembly mounting plate (locate at the back) and the
hole that goes completely through the top and bottom of the leg.
30.
Verify that the modem’s power switch is turned
OFF
.
31.
At the transit case, locate the pouch attached to the inside of the
case’s lid and remove the GPS (with cable), 3ft RG6 Coax cable,
and power cable.
NOTE
: Ensure that the 90° connector is firmly attached to the 3ft
RG-6 Coax cable if not already installed on the TRIA (hand
tightened only) as shown in Step 21.
32.
Connect the end of the GPS cable to the “GPS” port on the back
of the modem and place the other end (with the GPS) at least 5ft
way.
33.
Connect one end of the 3ft RG6 Coax cable to the “Antenna” port
on the back of the modem assembly and connect the other end
with the 90° connector fitting to the “TX” port on the TRIA.
