SurfBeam® 2 Pro Portable Terminal Operations Guide
© 2014 ViaSat, Inc.
Page 2-9
All Rights Reserved
ViaSat Proprietary Information
Step
Action
Image
17.
Mount the Assembly to the back of the Reflector using the four
attached screws (hand-tighten these screws only), where the top
of the Assembly points to the ViaSat logo.
18.
Remove the Reflector and Assembly from the case, and slide the
Assembly onto the Tripod’s post and rotate it to ensure proper
seating (revealing a 1/4-inch gap between the Assembly’s collar
bottom and the top of the Tripod’s legs).
19.
At the transit case, fold back the layer two felt divider and
remove one of the Edge Reflectors.
20.
Attach the Edge reflectors to each side of the Center Reflector
(one at a time) using the attached screws (hand-tighten these
screws only).
NOTE
: For each Edge reflector, start by tightening the middle
screw first and then tighten the two outer screws.
21.
At the transit case, fold back the layer two and three dividers and
CAREFULLY
remove the TRIA (lifting the TRIA by the housing and
NOT
the Feedhorn).
22.
Visually inspect the TRIA to ensure no damage has occurred and
that the Splash Plate is properly seated on the Feedhorn.
