SurfBeam® 2 Pro Portable Terminal Operations Guide
© 2014 ViaSat, Inc.
Page 3-7
All Rights Reserved
ViaSat Proprietary Information
3.5
Modem Relocation
After performing the assembly of the Pro Portable Terminal (complete sections 2.2, 3.2 through 3.4 before starting
the process below), the user can now relocate the modem. Table 3-5 provides the instructions on this process.
Table 3-5: Modem Relocation Process
Step
Action
Image
1.
Record the GPS Latitude and Longitude while the modem is on
and connected to the antenna with the 3’ Coax cable.
2.
Power
OFF
the modem assembly.
3.
Disconnect the power supply cable from the “Power Input” port
on the back of the modem and the grounded AC power outlet.
4.
Place the modem assembly and GPS in the desired location, and
connect the Coax cable of the required length.
5.
Connect the power cable to the power supply brick and twist the
connector onto the “Power Input” port on the back of the
modem assembly.
a.
Twist the cap until it stops clicking and the blue ring on the
cap covers the red ring on the modem port.
b.
Plug the end of the power cable into a grounded AC power
outlet. (
DO NOT
connect to ungrounded power sources, as
this will severely damage the unit.)
6.
Power
ON
the modem assembly.
7.
After turning on the modem, the LED display shows the
Start
screen. The LED display is controlled by the
Up
/
Down
,
Right
/
Left
,
ESC
, and
ENT
buttons located to the right of the LED
display. While the
Start
screen is displayed, press the
ENT
button
to access the
Main Menu
screen.
8.
On the
Main Menu
screen, use arrow keys to scroll to “
→ 2. GPS
”
menu item and press
ENT
button.
NOTE
: Pressing the
ENT
button will select whatever option’s
displayed on the middle line and identified by “→”.
NOTE
: If the display shows a checkerboard pattern (a screen
saver), press any of the four Arrow Keys to continue..
