Scan
- Tap on the Scan tab once the test set has detected the wireless USB adapter. Press Scan on the bottom to start scanning
the site. When scan is completed, the test set will show the number of SSIDs, Channels, and the number of SSiDs in
Infrastructures mode and Ad-Hoc mode.
SSiD
- Tap on the SSiD tab after the scan is completed. Select one of the SSiDs to start a connection. If the SSiD is locked, a
network key is required to complete the connection. The WiFi function supports WEP encryption. The key can either be 10
characters or 26 characters. Note: If the user entered the wrong network key the test set will still connect to the Access Point,
however, it will not be able to connect to the web or to perform the Ping test.
Note:
Select the manual selection to enter the parameters manually if the SSiD did not detect the AP that the user is searching
for.
WiFi Scan mode
WiFi SSID discovery
8.4.2 Connection Status
Once connected, the connection screen will display the following information on the connection;
SSiD
BSSiD MAC address
Channel number
Encryption type - WEP, WPA, Disabled
Type - Adhoc, Infrastructure
Signal strength is constantly updated so the value varies.
Link Quality is constantly updated so the value varies.
8.4.3 Ping
Before performing the Ping test, ensure the WiFi connection is Up and the WiFi icon (on the top of the screen) has turned green.
WiFi Connection
WiFi Ping testing
MX100/120 e-Manual D07-00-004 Rev A04
Page 84 of 115
