Note: Control Mode
Depending on the Control Mode selected (e.g. Asymmetric mode), test settings for upstream and downstream
are also displayed
Latency tab:
User configures;
Test:
Throughput Rate or Custom Rate. The default value is throughput.
Throughput rate
- latency test will be performed at the throughput rate found for each of the tested frame
sizes.
Custom rate
- user configures a custom rate in % or Mbps
Rate:
Only available if Custom Rate is selected'. Enter up to 100% of the negotiated line rate or enter the rate
in Mbps.
Duration:
5 to 999 seconds. The default value is 20 seconds.
This is the amount of time that the latency test will be performed for each test frame size.
Repetitions:
1 to 100. The default value is 1.
This is the amount of times that the latency test will be repeated for each test frame size
RFC2544 Setup - Latency Throughput Rate
RFC2544 Setup - Latency Custom Rate
MX100/120 e-Manual D07-00-004 Rev A04
Page 46 of 115
