purchased.
MAC, VLAN, MPLS, and IP:
To configure the MAC addresses, VLAN ID/priority, MPLS label/CoS/etc, IP
addresses and header, tap on the 3-D image of the frame on the screen. This will bring you to the
configuration screens for all the header fields.
MAC Header Tab:
In the MAC tab the user must configure the destination MAC address of the far end
partner test set. For the source address use the default source address of the test set or configure a different
one. Depending on the type of frame the user may also configure an Ethernet Type filed (Ethernet II frame),
LLC header fields (802.3 LLC frame), or SNAP header fields (802.3 SNAP frame).
VLAN Tab:
In the VLAN tab the, the VLAN ID, priority, and Tag Type (or Ethernet Type) can be configured
for all available VLANs.
MPLS Tab:
In the MPLS tab the MPLS label, CoS priority settings, TTL, and S-bit fields are configured for all
available MPLS tags.
IP Tab:
In the IP tab the user must configure the destination IP address and source address. The user may
also configure the following IP header fields; IP TOS (for quality of service testing), TTL, fragment offset byte,
and the protocol field.
RX Filter:
Filter traffic by MAC or IP source and destination addresses or VLAN tag.
Throughput Setup - Stream list
Throughput Setup - Header / Stream #1
Throughput - Header / Stream #2 Throughput - Header / Stream #3 Throughput - Header / Stream #4
MX100/120 e-Manual D07-00-004 Rev A04
Page 56 of 115
