V-301Series Operating Instructions 3.02E
10
Ɣ +HDWLQJWHPSHUDWXUHVKRXOGEHVHWDWDPLQLPXP
Set sealer so that an acceptable seal is completed in the least amount of
heating time.
Excessively long heating time will damage the fluoro glass sheet, glass
tape and other consumables, as well as result in heating element
breakage. This will lead to decreased work productivity and
unnecessary power consumption.
Ɣ $OORZVXIILFLHQWFRROLQJWLPH
With an impulse type sealer, residual heat after the heating cycle has
been completed is dispersed through the pressure lever and machine
frame, allowing the film to set under pressure.
Release the table after “beeping” (indication buzzer for seal
completion) sounds.
If the table is released before the buzzer, seal performance will be not
good.
Refer to
"8-11 Cooling process"
.
Ɣ :KHQWKHIOXRURJODVVVKHHWDQGVLOLFRQHUXEEHUDUHGDPDJHG
The fluoro glass sheet and silicone rubber will start to wear with use.
Once they are damaged, it will be difficult to achieve smooth and strong
seals.
Thoroughly read how to replace the parts and be careful when doing so.
Caution
Be careful with the nozzle
After the sealing process, nozzle comes forward automatically.
Please take sufficient care not to put hand or face close to nozzle.
Also, if the sealed pouch is left to the sealing area after sealing, the
nozzle may break the bag when it is moving forward.
Caution
When the frame cover is opened
Inside the sealer's body, there are metal plate parts which have sharp
edge.
If the frame cover would be removed for the replacement of parts,
please take care not to be injured.
For smooth operation