V-301Series Operating Instructions 3.02E
7
POWER
POWER
HEAT C
YCLE
HEAT C
YCLE
VAC CY
CLE
VAC CY
CLE
HEAT T
IMER
HEAT T
IMER
VAC TIM
ER
VAC TIM
ER
VACUUM
START
VACUUM
START
NOZZLE
IN/OUT
NOZZLE
IN/OUT
CA
UTION
HOT
CAUTION
UN
PLU
G B
EFO
RE
P E
R F
O R
M I
N G
MAINT
ENANCE.
CAUTION
HOT
SHOCK
WARNING
Caution
W2135
UNPLUG BEFORE
PREFORMING
MAINTENANCE.
1
The impulse sealer is a machine which sends strong electric current quickly to the thin ribbon
heater, which presses against the film and instantly heat seals the package. Though this machine
yields superior quality sealing, it is not compatible with films thicker than that indicated in the
diagram below, sponge-like sheet, and materials which are not able to withstand high heat.
2
Vacuum packaging requires a laminated pouch made with high-barrier property materials such as
nylon-based films. Using films with low gas barrier properties will allow air to seep into the pouch
over time, negating the effectiveness of a vacuum seal.
3
Film thickness limits for the V-301 and V-301-10DK are described below. The machine cannot seal
pouches which are thicker than the indicated. The machine may malfunction if you try to exceed
the limits of the machine.
Warning - Caution labels are placed in locations where there is a danger of injury to a person or damage to the
machine. Label location details are illustrated below.
Please check them before beginning operation.
Labels not readily apparent are indicated by dotted lines.
Heating method
Model
Heating element
width
Film thickness
(Total thickness of overlapping sheets)
Single side heating
V-301
5mm
0.3mm or less
Single side heating
V-301
10mm
0.4mm or less
Double side heating
V-301-10DK
10mm
0.5mm or less
4 Proper operating boundaries for the V-301 series
5 Warning - Caution label location and content
This label is placed on the right side of the frame.
This label is placed on
the pressure lever.
This label is located on the back of
the frame cover.
If Warning, Caution labels peel off or are lost, please purchase the proper
labels and place them in the appropriate location.