V-301Series Operating Instructions 3.02E
13
POWER
POWER
HEAT CY
CLE
HEAT CY
CLE
VAC CY
CLE
VAC CY
CLE
HEAT TIM
ER
HEAT TIM
ER
VAC TIM
ER
VAC TIM
ER
VACUUM
START
VACUUM
START
NOZZLE
IN/OUT
NOZZLE
IN/OUT
POWER
POWER
HEAT CY
CLE
HEAT CY
CLE
VAC CY
CLE
VAC CY
CLE
HEAT T
IMER
HEAT T
IMER
VAC TIM
ER
VAC TIM
ER
VACUUM
START
VACUUM
START
NOZZLE
IN/OUT
NOZZLE
IN/OUT
This machine is a desk type sealer. Place the machine
on a flat, horizontal surface and secure an appropriate
workbench.
1
Remove the plastic nuts (white) attached to the
table. Insert the screw shaft of the table to the
holder as per in the right illustration.
2
Then tighten two screws with the plastic nuts
(white).
Push the power switch located on the top of the frame.
Power lamp on the control panel will light up.
Use only as described in this manual.
There is a risk of danger and malfunctions may result if the machine is used not in accordance with this manual.
The power cord is located on the left side of the
machine, when facing toward it. Make sure the
electrical outlet has adequate current carrying capacity
for your machine. Insert the electric power plug fully
into the wall outlet.
8 Proper use of the sealer
8-1 Securing the machine
8-2 Table attachment
8-3 Plugging in the electrical power
cord
8-4 Power switch ON
Plastic nut(white)
Power switch
Push
Holder
Warning
Installing the machine on an unstable or
inclined surface may cause the overturn of
the sealer.
Warning
There is a danger of fire if the electrical
power source does not meet proper
specifications.
