5-24
Valco Cincinnati, Inc.
Section 5 - Operation
MC091 - VCX OT-120 FlexosealPro 2 - Corrugated
Configure the Inspection
Sensor(s) - Continued
Name
Use
Sensor Number
Displays the number of the current inspection sensor.
Start Tolerance
The inspection tolerance for the start of the glue line. (Changes
with the tolerance level.)
End Tolerance
The inspection tolerance for the end of the glue line. (Changes
with the tolerance level.)
Tolerance Mode
(Level Adjustment)
Quickly adjusts the inspection tolerance to a small amount (1),
a medium amount (2), or a large amount (3). There is also a
User Selectable adjustment mode, allowing more exact
settings for start/end tolerance.
Inspect Unglued Areas On/Off Switch
When on, the inspection sensor will inspect these unglued
areas according to the tolerances entered. When off, these
areas are ignored.
Target Glue Position
The desired glue position, per settings.
Measured Glue Position
The actual, measured glue position.
Volume Enable On/Off Switch
Turns the Glue Volume Inspection on or off. The sensor will not
inspect the glue volume if this switch is off.
Volume Tolerance
The inspection tolerance for the amount of glue on the product
(not available if the Glue Volume Inspection Switch is off).
(Changes with the tolerance level.)
Inspection Enable On/Off Switch
Switches the inspection sensor off and on. If bad products are
going through without being sensed, check to make sure this
switch is on.
Glue Line Length Sensor
Displays the length of the glue line (appears blank if the
Inspection Valve is turned off).
Setup Menu Button
Press to make adjustments to the sensor.
Tolerance Menu Button
Press to fine-tune the inspection tolerances. This is covered in
Section 6 – Customize the FlexosealPRO.
Learn Volume
Press to “teach” the sensor the glue volume while glue is being
applied. This is covered in
Section 6 – Customize the
FlexosealPRO2.
Diagnostics Button
Press to use the Diagnostics. This is covered in
Section 6 –
Customize the FlexosealPRO2.
Confirmation Button
Press to enter the new settings and go back to the Main Menu.