VADDIO 999-60210-000, Complete Manual

Page: 157 / 176

Camera
What is it doing? Possible causes Check and correct
The light on the front of the
camera is off but it responds to
controls. The status light is turned off.
This is normal.
You can turn the light on again using the
LED On setting on the General tab of
the System page, or using the Telnet
command
camera led on
.
The camera is not responding
to controls and the light is
yellow. A firmware update is in
progress.
This is normal.
Wait a few minutes, and try again when
the light turns blue.
The camera does not respond
to the remote, but it can be
controlled using the web
interface. The remote is not using the
same IR channel as the
camera. Push the Camera Select 1 button on the
remote. Try Camera Select 2 or 3 if that
doesn't work.
The batteries in the remote are
dead. Put new batteries in the remote.
The batteries were installed
incorrectly in the remote. Install the batteries as shown in the
diagram inside the remote.
All the cameras in the room
respond to the remote at the
same time. All the cameras are set to
respond on the same
frequency. Set each camera to a different IR
channel. See
Setting Cameras to
Respond Independently to the IR
Remote
.
The camera does not appear in
the EasyIP Decoder's list of
inputs. The camera is not paired to the
decoder. Add the camera to the decoder's
directory. See
Setting Up the Directory .
The camera is not listed among
the cameras available to the
EasyIP Decoder or EasyIP
Mixer The camera and managing
device are on different subnets. Add the camera by entering its IP
address manually in the Input Pairing
dialog box.
The camera is operating
normally but its indicator light is
red. The camera is using the pro
A/V LED color scheme, and is
the currently selected video
input. This is normal.
150
Complete Manual for EasyIP Systems