Unipro UniGo 5005, User Manual

Page: 31 / 56

31
Setup mode
C o n f i g u r i n g
t h e L a p t i m e r
RUN-IN TIME
When breaking in a new engine you have
to set the time the driver should run before
returning to the pit. In engine run-in mode,
the lap time is not shown, but instead a count
down timer. This value is the starting value of
this counter.
RUN-IN TEMPERATURE
The temperature is typically very important
when breaking in a new engine and here the
target value is set. The target temperature is
the temperature you want to aim at, and do
not want to exceed too much.
RUN-IN TEMP CHANNEL
Depending on temperature is connected to
either the temp 1 or temp 2 input, you can
select the temperature channel used when
breaking in a new engine here.
RUN-IN REVS
The most important parameter when breaking
in a new engine is the target RPM value. Here
you set the RPM value the driver should aim
at, but not exceed too much.
UNIGO MENU
The UniGo menu contains all the settings
related to the UniGo.
Use the up ( ) and down ( ) buttons to
move around in the menu and press the ok
button ( ) on the relevant line to change the
value. To accept the changes press the
ok but-
ton ( ) again or press back ( ) to cancel the
changes and revert to the original value.
LANGUAGE
UniGo can speak several different languages.
Here you can chose between the available
languages. All text is changed to the new
language as soon as it is selected. The name
of the language is always a three letter ab-
breviation. Even if you select a language you
cannot read, you can still see the names of the
languages.
SET UP SCREENS
The different run modes have different number
of data fields. All of them are configurable.
This is done from the screen setup screen.