Unipro UniGo 5005, User Manual

Page: 51 / 56

51
Weak and hard to read text
The contrast is set too low.
• Adjust the contrast to a higher value.
The Laptimer turns off when using a LiPo
battery
The discharge curve for a LiPo battery is very
steep. The battery warning level is not set
correctly.
• Set the battery warning high enough to
be warned in time. For a LiPo battery we
recommend a setting of 7.5 Volt.Please
see “BATTERY EMPTY” on page 34.
One of the temperatures do not show up
in run mode
The sensors are not detected at startup.
• Contact your dealer to order a new but-
ton as a spare part.
The lap number is increasing every
second
The splitter is not mounted correctly.
• Please make sure the receiver is in input
#1 and the speed sensor in input #2.
Unstable data values in run mode
Excessive noise from the ignition system.
• Change to a noise reduced spark plug.
• Mount a ferrit bead on the cylinder plug
sensor cable (conact Unipro).
• Run the ignition wire as far away from
the other cables.
UniGo is not turning on
Batteries might be empty.
• Press and hold the mode button (
1
)
for at least 10 seconds. Then try to turn
UniGo on again.
• Change or recharge the batteries.
The gear indicator is not working in run
mode 2
The number of gears is not set correctly.
• Set the correct number of gears and then
go through the learning process.
No temperature shown when using a
splitter
A wrong splitter is used.
• You need to use the gray splitter. A
black splitter cannot be used for the
temperature sensors.
UniGo shows an error message
Something went wrong!
• Please contact Unipro at
support@uniprolaptinmer.com
We expect a smooth and pleasurable experience when using
UniGo.
If you have any problems, either with the setup or with daily use,
please check the following pages for suggested solutions.
If you don’t find the answer to the problem here, please contact
your Unipro dealer for further assistance.
T r o u b l e -
s h o o t i n g
Troubleshooting
51