Unipro UniGo 5005, User Manual

Page: 25 / 56

25
C o n f i g u r i n g
t h e L a p t i m e r
Configuring the Laptimer
This chapter will learn you all about the configuration of UniGo.
Entering setup, most often settings, and every single setting.
A correct setup is essential for the maximum performance of
your Laptimer so make sure to read this chapter carefully.
You will be ready to go in 5 minutes...
ENTER SETUP MODE
You enter the Setup menu directly from
the main menu.
Entering setup mode is from the main
menu.
When entering setup you will see the setup
menu as shown below. Here you will find
all settings divided into different submenus.
These submenus are explained in this chapter.
The setup menu contains the icons for the
different settings.
GENERAL SETUP FEATURES
In Setup mode you use the up ( ) and down
( ) buttons to move around in the menu and
press the
ok button ( ) on the relevant line to
change the value. To accept the changes press
the
ok button ( ) again or press back ( ) to
cancel the changes and revert to the original
value.
If a menu line is ending with “:” it means the
value can be changed directly by pressing the
ok button ( ). If the line is ending with “...” it
will go into another submenu.
All settings are stored in two different files.
The first file contains all the local settings
and it is called “LocalSetup.bin” located
in the \Setup folder. The other file is called
“GlobalSetup.bin” and located in the same
folder. The global setup file can be copied
from one UniGo to another. It contains all the
settings that makes sense to copy from one
UniGo to another.
All settings are stored and will not be cleared,
even if you remove the power from UniGo.
MOST USED MENU
The most used menu contains all the
settings you use very often. You will find the
same settings in other submenus, but to make