Unipro UniGo 5005, User Manual

Page: 12 / 56

12
UniGo mounted at the correct distance to
the steering wheel.
Before tightening the nut, make sure that all
the cables can be connected without conflict-
ing with the steering wheel or other obstacles.
CONNECTING POWER
UniGo is supplied with a battery holder
with room for six AA batteries. You can use
standard AA Alkaline batteries or rechargeable
types like NiMH. Make sure the battery holder
is securely attached to the frame. If any of the
batteries are allowed to move and loose con-
tact, the Laptimer will not functioning properly.
Battery holder with six AA Alkaline batteries
powering UniGo. Rechargeable can be used.
Another alternative is to power UniGo from a
standard rechargeable battery pack or from
the go-kart battery through the optional DC/DC
converter.
Rechargeable battery pack powering UniGo.
A rechargeable battery pack will give a lot of
power with a low weight. It can be recharge
using the same connector as used for the go-
kart’s battery.
Withthe the DC/DC converter you can power
the Laptimer directly from the go-kart’s battery.
CONNECTING RPM WIRE
The RPM wire is used to pick up the engine’s
revolution count by sensing the pulses on the
ignition cable going from the ignition coil to
the spark plug.
The ignition is a very noisy signal and extra
care should be paid on installing the RPM
wire.
The wire can be removed from the Laptimer
and attached again if needed. It is simply a
wire going through two holes with a loop.
Run the RPM wire away from other cables.
To make the best possible installation, keep
the RPM wire away from all other cables.
Installation
I n s t a l l i n g t h e
L a p t i m e r