Unipro UniGo 5005, User Manual

Page: 27 / 56

27
Setup mode
C o n f i g u r i n g
t h e L a p t i m e r
MAGNET COUNT
If the receiver is set to magnet, the Laptimer
need to know the number of magnets on the
track. This is the total number of magnets the
kart will pass on one lap.
MAGNET DELAY
This is the number of magnets you need to
skip when going from the pit to the start/finish
line. If the delay is set to 2, it means that on
the out lap (or first lap) the Laptimer ignores
the first two magnets and then start the
Laptimer when passing the third one.
IR OR LOOP DELAY TIME
If the receiver is set to infrared or loop, you
can chose a minimum delay from one trig to
the next. This is the minimum time allowed
between two trigs. This is primarily used if an
infrared transmitter can reach across the track
and then trigger the Laptimer more than once
on the same lap.
SPLIT TYPE
5005
The typically split type is using several magnets
per lap. Sometimes it a better option to use
the wheel sensor for setting your own splits.
To get reliable splits, make sure the
sensor is mounted on a wheel without
brakes.
SPLITS
5005
The splits menu is a submenu where all the
individual split points are set. It is possible
to set up to 8 split points per lap. The 8 split
points will give you 10 times per lap. You will
get 8 split times, and then an extra time from
the last split point to the start/finish line. And
then of course the lap time.
SPLITS MENU
5005
The first thing to set is the number of splits per
lap. This can be between 1 and 8. When the
split count is changed, the correct number of
split points are enabled for editing. Set each
point as you like and enter the number in
either meters or feets.
Splits from wheel sensor with 4 splits pro-
grammed.
Notice that the split points are part of
the global setup and they can easily be
moved from one Laptimer to another.
KART MENU
The kart menu contains all the settings
related to the kart.
All settings releated to the kart are on the
kart menu screen.
Use the up ( ) and down ( ) buttons to
move around in the menu and press the ok
button ( ) on the relevant line to change the
value. To accept the changes press the
ok but-
ton ( ) again or press back ( ) to cancel the
changes and revert to the original value.
WHEEL SIZE
The wheel circumference is entered in either
millimeters or inches and you need to measure
this quite often to keep the system accurate.