Ulvac MS120A, Instruction Manual

Page: 26 / 69

12
YO20-0938-DI-001-00
Key/LED Function
J
LEFT key
Switch which moves the digit to the left in the controller operation mode.
UP key / DOWN key
／
Switch which selects the status to monitor or proceed to the next item and data.
RIGHT key (RESET
key)
Switch which moves the digit in the controller operation mode to the right.
Functions as the alarm reset key in the event of an alarm.
ENTER
key
Switch which displays or accept the status to monitor.
Used to move from one screen to the next screen.
K
ESC
key
Switch which returns to the previous status before pressing the ENTER key.
Table 3 : Display and status of indicator lamps
Indicator lamp
Display Status
RUNindicator
lamp
ON
Running
Blink Decelerating and stopping
Short
blink
・
Operation command right was switched to REMOTE while the operation
command was input from the outside in the LOCAL mode.
・
External interlock signal was input.
・
External interlock is activated and inverter has cut off.
・
has pressed and operation stopped when operation command was
REMOTE mode.
REV indicator
lamp
ON
Normally does not light up. (A state where the reverse command is input)
OFF
Normal state.
ALM indicator
lamp
ON
Alarm has detected.
Blink Warning detection before alarm activation.
OFF
Normal status without warnings or abnormalities.
DRV indicator
lamp
ON
Drive mode.
Blink Internal sequence is running.
OFF
Program mode.
LO/RE indicator
lamp
ON
Operation command right is set to the controller (LOCAL).
OFF
Operation command right is set to an external command (REMOTE) other than
the controller.