Page 74
T47541109 Rev. J
FlexJet Head Assembly
TECHNICAL
PUBLICATIONS
This Document Supports Assembly 47541109 Rev. F
6.
Install the following 2 cables from the 2.6 OTH Camera Assembly to
the PC board. Refer to the following wiring chart and diagram.
From
To
Mirror Clear Sensor/P15
15PL
Mirror In Range/P16
16PL
7.
Install the (camera) lighting cables 35PL-39PL to the PC Board. (Ex:
35PL connects to P35.) Refer to the following wiring chart.
From
To
LED Asm, Front
Lighting
35PL, 36PL
LED Asm, Side
Lighting
37PL, 38PL
PCB, On Axis
Lighting
39PL
8.
Install all cables from the clutches, Z Motors, and Manifold Assembly
to their corresponding location on upper portion of the PC Board.
Work from the topmost connectors down. If necessary, remove a few
tie wraps before beginning and install new tie wraps afterward.
Example: 17PL connects to P17.
Final Steps
It is important to connect the HD INTF2 (Power) Cable Assembly first to
protect the circuitry from ESD.
1.
Configure the jumpers shown below to be the same as the jumpers on
the old PC Board. Refer to the following diagram.
CAM INTF Cable Assembly
HD INTF 1
Cable Assembly
Jumpers
