Page 49
FlexJet Head Assembly
T47541109 Rev. J
TECHNICAL
PUBLICATIONS
This Document Supports Assembly 47541109 Rev. F
Then use a dry swab to clean the same Pin Mirrors before the solution
dries on them.
Do not let go of the Spindle until it is fully in the up position, or the
return spring may cause the Spindle to abruptly impact the Optic
Bracket.
6.
Carefully return the Spindle to the up (home) position.
7.
Repeat the procedure from step 3 until all 14 Pin Mirrors on the 7
Spindles are clean, then continue with the next procedure.
Verify/Adjust the Camera Mirror Cable
Use the following procedure to verify the camera cable adjustment. After the
cable is adjusted, proceed to the next section.
1.
Use feeler gauges to verify the gap shown in the diagram below. Refer
to the Verifying/Adjusting the Mirror Gap procedure in the Camera
Assembly, 2.6 OTH document for the proper gap specification.
Gap
2.
If the gap is out of adjustment, perform the following steps. Otherwise
proceed to the Inspect the Mirror Spring Shaft procedure.
a.
Rotate the cable adjustment screw clockwise or counter-
clockwise to achieve the gap specified in the Camera Assembly,
2.6 OTH document. See the diagram to the left.
Cable Length
Adjustment Screw
