Page 31
FlexJet Head Assembly
T47541109 Rev. J
TECHNICAL
PUBLICATIONS
This Document Supports Assembly 47541109 Rev. F
If air kiss is present for all 7 spindles, continue with the next step.
2.
Perform the following steps to turn off air kiss for all spindles.
a.
Select the
Tool #
. Begin with tool number 1.
b.
Verify that
AIR_KISS
and
MAIN_VACUUM_CONTROL
are
highlighted in the
Select Outputs
field.
c.
Select
Reset Outputs
.
d.
Repeat steps 2a to 2c until air kiss in turned off for all 7 spindles.
e.
Select
Exit
.
Final Steps
1.
Select
System Setup > Machine > Setup > Head/Changer
Nozzle Setup
to install the nozzles removed earlier. It is
recommended to inspect the nozzles before installation.
2.
Verify that the head nozzle configuration is correct by selecting
Machine > Configuration
. Then select the head icon to access the
configuration window.
3.
Close the hinged cover.
4.
Palm down to automatically raise the spindles. The spindles move up
in stages to prevent sudden impact.
5.
Install the safety cover below the hinged cover.
6.
Install any feeders removed earlier. Ensure that the feeders match the
feeder configuration in UPS.
7.
Record on the appropriate copied sheet from the Maintenance Log
document that this procedure was performed and include the date.
Inspecting the Theta- and Z-Motor Belts
Use the following procedure to inspect the FlexJet Theta- and Z-Motor Belts
for missing teeth or other obvious damage.
Initial Steps
1.
Use
Manual Control
to move the beam(s) to a convenient
maintenance location. For more information, refer to the Manual
Control section of Machine Configuration.
