Page 72
T47541109 Rev. J
FlexJet Head Assembly
TECHNICAL
PUBLICATIONS
This Document Supports Assembly 47541109 Rev. F
1.
Disconnect the HD INTF1 Cable Assembly and CAM INTF Cable
Assembly. Refer to the following diagram.
HD INTF 2 Cable
Assembly (Power)
CAM INTF Cable Assembly
HD INTF 1
Cable Assembly
2.
Remove all electrical cables from the PCA FlexJet Control except the
HD INTF2 (Power) Cable Assembly.
3.
Disconnect the HD INTF2 (Power) Cable Assembly last.
4.
Remove the 2 top screws and washers securing the PCA FlexJet
Control to the top bracket.
5.
Remove the 4 screws and washers securing the Bracket to the Platform
Assembly and remove the Bracket and PCA FlexJet Control.
6.
Remove the 4 screws and washers and remove the Bracket from the
PCA FlexJet Control.
7.
Wearing an ESD wrist strap, carefully remove the E-Prom from the old
PC board and install it in the same orientation on the new PCA FlexJet
Control.
Install the New PCA FlexJet Control
1.
Install the Bracket to the new PC board with the 4 screws and washers.
2.
Install the 2 top screws and washers to secure the PCA FlexJet Control
to the top bracket.
3.
Install the 4 screws and washers to secure the lower bracket to the
Platform Assembly.
