UDO Super Gemini — Owner’s Manual
66
The delay send fader.
SEND:
This fader controls how much of each layer’s output is fed into the
delay effect. Higher settings result in a wet effect mix, while lower settings
emphasise the dry signal.
Delay Freeze
The Super Gemini also features a delay freeze function that enables you to
create sound-on-sound loops while you are performing. Follow the steps
below to access this feature:
1.
Turn off the Super Gemini.
2. Connect a single or dual footswitch to the delay freeze input on the
rear panel. When using a single footswitch, it controls the upper
layer delay freeze function. When a dual footswitch is connected,
the left pedal controls the upper layer delay freeze function, while
the right pedal controls the lower layer delay freeze function.
3. Power cycle the Super Gemini. The connected footswitch will auto-
calibrate for polarity when the instrument is switched on.
To add notes or chords to the delay loop, release the footswitch while
playing. Once you hold down the footswitch, new notes will no longer be
added to the delay loop while its current content loops endlessly.
Use the
SEND
control to set the level of the delay loop, the
TIME
control
to set the length of the delay loop and the
FEEDBACK
control to ensure
that looped notes are repeated at a constant level. Delay freeze works best
with long delay times and moderate amounts of delay feedback.
You can also control the delay freeze function via MIDI. It sends and
receives MIDI data via CC69.
Summary of Contents for SUPER GEMINI
Page 136: ......
