turck TBEN-L4-4RFID-8DXP, Instructions For Use Manual, Page: 148 / 242

Setting
RFID channels – overview of commands
148
Hans Turck GmbH & Co. KG | T +49 208 4952-0 | F +49 208 4952-264 | more@turck.com | www.turck.com
8.8.25 Command: Backup settings of the UHF read/write head
NOTE
The command is only available for UHF applications.
The Backup settings of the UHF read/write head command saves the current settings of the
connected read/write head in the memory of the interface. The backup is retained also after the
voltage of the interface is reset. The
Restore UHF read/write head settings command can re-
store the backup data when a device is swapped. Type and firmware version must be identical
for both read/write heads.
Request
Loop counter See description of the output data, [
}
99]
Command code 0x1001 (hex.), 4097 (dec.)
Read/write head address See description of the output data, [ } 99]
Length UID/EPC Not required
Start address Not required
Length Not required
Command timeout See description of the output data, [
}
99]
Write fragment no. 0
Read fragment no. See description of the output data, [ } 99]
Write data Not required
Response
Loop counter See description of the input data, [ } 93]
Response code 0x1001 (hex.), 4097 (dec.)
Length Not required
Error code See description of the input data, [ } 93]
Tag within the
detection range See description of the input data, [ } 93]
Data (bytes) available See description of the input data, [ } 93]
Tag counter See description of the input data, [
}
93]
Write fragment no. 0
Read fragment no. See description of the input data, [ } 93]
Read data Not required