Triple-IN
GmbH
© Triple-In GmbH • 27/01/2016 11:07:00
PSxxx-20 Laser Scanner User's Manual
32
32
32
32
3 - Show reference tables...
4 - Restore to factory settings
E - Edit parameter
S - Take a scan
L - Switch laser marker
0 - Exit to Run Mode
Show user parameter
Show user parameter
Show user parameter
Show user parameter
Lists the parameters set by the user. With the function "Edit parameter" these
values can be edited.
Show system he
Show system he
Show system he
Show system health status
alth status
alth status
alth status
List the results of the self-test.
Show reference tables
Show reference tables
Show reference tables
Show reference tables
Displays the firmware versions and parameter code reference tables.
Restore to factory settings
Restore to factory settings
Restore to factory settings
Restore to factory settings
This function is used to set parameters to their default values.
IMPORTANT
IMPORTANT
IMPORTANT
IMPORTANT
All changed user parameters will get lost.
Edit parameters
Edit parameters
Edit parameters
Edit parameters
This function is used to change any parameter. The parameter codes are needed
for this. After entering the parameter code the firmware shows the current value,
the measurement unit and the valid range of values. The program then asks
whether the changed parameters should be stored in the flash.
> E
> Enter parameter ID:
3_
> Enter parameter "Scan mode: 0=off, 1=normal, 2=fast, 3=fine, 4=reserved;":
2_
Take a scan
Take a scan
Take a scan
Take a scan
Starts the motor and carries out a single scan. The result is presented as CVS table.
This function shall be used to check the basic functionality of the sensor.
