TRENDnet TPE-3012LS, User Manual, Page: 96 / 187

© Copyright 2020 TRENDnet. All Rights Reserved.
TRE
NDnet User’s Guid e
TPE-3012LS / TPE-3018LS
92
Add multicast router ports
Multicast > General > Router Port
Static router ports can be specified for multicast traffic in this section.
1. Log into your switch management page (see “ Access your switch management page ”
on page 11).
2. Click on Multicast , click on General , and click Router Port .
3. Click Add to add a new static muliticast address entry.
•
VLAN – In the Available VLAN list, select the VLAN IDs to assign the multicast
router ports. You can use the arrow buttons to add and remove to
the Selected VLAN list.
Note: Multiple VLAN IDs can be selected at the same time by holding the Shift
or Ctrl key.
•
IP Version – Select the IP address version of the multicast static address, IPv4
or IPv6 .
•
Port – In the Available Port list, select the static multicast router ports to
configure. You can use the arrow buttons to add and remove to the
Selected Port list.
Note: Multiple ports can be selected at the same time by holding the Shift or
Ctrl key.
4. Click Apply .
5. In the top right, click Save to save the configuration settings to NV-RAM/startup
configuration.
6. Click OK .