TRENDnet TPE-3012LS, User Manual, Page: 132 / 187

© Copyright 2020 TRENDnet. All Rights Reserved.
TRE
NDnet User’s Guid e
TPE-3012LS / TPE-3018LS
128
Configure MAC ACE
ACL > MAC ACE
This section allows users to configure access control entries/policies for the MAC ACLs
defined and filtered based on MAC address.
1. Log into your switch management page (see “ Access your switch management page ”
on page 11).
2. Click on ACL and click on MAC ACE .
3. Review the settings below.
Item Description
ACL Name Display the ACL name to which an ACE is being added..
Sequence
Specify the sequence of the ACE. ACEs with higher
sequence are processed first (1 is the highest priority). Only
available on Add Dialog.
Action
Select the action after ACE match packet.
●
Permit: Forward packets that meet the ACE criteria.
●
Deny: Drop packets that meet the ACE criteria.
●
Shutdown: Drop packets that meet the ACE criteria, and
disable the port from where the packets were received.
Such ports can be reactivated from the Port Settings
page.
Source MAC
Select the type for source MAC address.
1. Any: All source addresses are acceptable.
2. User Defined: Only a source address or a range of
source addresses which users define are acceptable.
Enter the source MAC address and mask to which will
be matched.
Destination
MAC Select the type for Destination MAC address.
●
Any: All destination addresses are acceptable.
●
User Defined: Only a destination address or a range of
destination addresses which users define are
acceptable. Enter the destination MAC address and
mask to which will be matched.
Ethertype
Select the type for Ethernet frame type.
●
Any: All Ethernet frame type is acceptable.
●
User Defined: Only an Ethernet frame type which users
define is acceptable. Enter the Ethernet frame type
value to which will be matched.
VLAN
Select the type for VLAN ID.
●
Any: All VLAN ID is acceptable.
●
User Defined: Only a VLAN ID which users define is
acceptable. Enter the VLAN ID to which will be
matched.
802.1p
Select the type for 802.1p value.
●
Any: All 802.1p value is acceptable.
●
User Defined: Only an 802.1p value or a range of 802.1p
value which users define is acceptable. Enter the 802.1p
value and mask to which will be matched.