© Copyright 2020 TRENDnet. All Rights Reserved.
TRE
NDnet User’s Guid
e
TPE-3012LS / TPE-3018LS
112
Configure Management ACL/ACE (Access Control Lists/Access Control Entries)
Security > Management Access > Management ACL
Access Control configuration allows you to control different aspects of the Ethernet
traffic as it enters the switch ports and is process through the Switch. You can specify
what traffic is permitted or denied to flow through the switch by setting up specific filter
criteria at an ingress port. You can also manage the switching priority of Ethernet
packets. All of this is done by specifying policies that define the filtering and priority
behavior.
Create new access control list
Security > Management Access > Management ACL
1. Log into your switch management p
age (see “
Access your switch management page
on page 11).
2. Click on
Security,
click on
Management Access,
and click on
Management ACL
.
3. In the
ACL Name
field, enter a name for the new access control list. Click
Apply
.
After creating the new ACL, it will appear in the Management ACL Table
4. To create a new policy under the new ACL, click on
Security,
click on
Management
Access,
and click on
Management ACE
.
5. Make sure the correct ACL is selected in the
ACL Name
drop-down list. Click
Add
to a
new policy under the ACL.
6. Review the ACE policy settings below.
•
ACL Name:
Displays the ACL name in which the new policy will be added.
•
Priority:
Specify the priority value for the policy. (Lower number is higher
priority. Ex: A value of 1 specifies the highest priority.)
•
Service:
Select the service or protocol for the policy.
o
All:
All ports and protocols.
o
HTTP:
Policy will only filter HTTP traffic.
o
HTTPS:
Policy will only filter HTTPS traffic.
o
SNMP:
Policy will only filter SNMP traffic.
o
SSH:
Policy will only filter SSH traffic.
o
Telnet:
Policy will only filter Telnet traffic.
•
Action:
Select the action for the policy.
o
Permit:
Forward the traffic based on the parameters specified in the
policy.
o
Deny:
Drop the traffic based on the parameters specified in the policy.
•
Port:
In the Available port list, select the ports the policy will be applied. You
can use the arrow
buttons to add and remove to the Selected Ports
list.
Note:
Multiple ports can be selected at the same time by holding the Shift or
Ctrl key.
•
IP Version:
Select the IP version used to identifiy the source IP address of the
traffic to apply policy.
o
All:
The policy will be applied to both IPv4 and IPv6 address source
traffic, all IPv4 and IPv6 addresses.
o
IPv4:
The policy will be applied only to IPv4 address source traffic.
o
IPv6:
The policy will be applied only to IPv6 address source traffic.
Summary of Contents for TPE-3012LS
Page 1: ...TRENDnet User s Guide Cover Page...
Page 187: ......