TRENDnet TPE-3012LS, User Manual, Page: 77 / 187

© Copyright 2020 TRENDnet. All Rights Reserved.
TRE
NDnet User’s Guid e
TPE-3012LS / TPE-3018LS
73
If the IP camera(s) that you are installing cannot be configured with a VLAN ID, then the
switch ports should be configured as Static tagged ports within the surveillance VLAN.
Note: The Surveillance feature can only be used if switch ports are set to Hybrid mode
under VLAN > Port Setting.
Create a Surveillance VLAN
Voice VLAN > Surveillance VLAN > Property
Note: Prior to configuring your voice VLAN, you must first configure a tagged VLAN. This
VLAN will be used as a basis for your surveillance VLAN.
1. Log into your switch management page (see “ Access your switch management page ”
on page 11).
2. Click on VLAN , click on Surveillance VLAN , and click on Property .
3. Review the settings. Click Apply to save the configuration settings.
Use the following procedure to configure surveillance VLAN:
•
State – Checking the Enable option will enable the Surveillance VLAN feature.
Unchecking the option will disable the Surveillance VLAN feature.
•
VLAN – Click the drop-down list to select the VLAN assigned as the designated
surveillance VLAN ID.
Note: The VLAN must be created under VLAN and VLAN Configuration first
before the VLANs are available in the drop-down list.
•
CoS / 802.1p Remarking – Check the Enable option to attach the specified
802.1p CoS priority tag to Surveillance VLAN traffic. Click the drop-down list to
select the 802.1p priority tag to assign to surveillance VLAN traffic.
Note: For the CoS priority to be effective, QoS must be enabled.
•
Port Aging Time - This parameter indicates the amount of time, in hours, after
the last IP camera's OUI was received on a port, after which this port will be
removed from the surveillance VLAN. The range is 30 to 65536 minutes.
4. Check the ports you would like to enable for surveillance VLAN auto-detection and
click Edit .
5. Under the port setting, check Enable to enable surveillance VLAN auto-detection on
the port.
Note: The Surveillance feature can only be used if switch ports are set to Hybrid mode
under VLAN > Port Setting.