Operator Manual Rev 1.1
Page 39
S
ERVICE
&
M
AINTENANCE
General
Please read carefully the chapter "T
RANSVIDEO
E
QUIPMENT
L
IMITED
W
ARRANTY
" about the Transvideo
S.A. warranty on the equipment described in this manual.
For repairs contact Transvideo S.A. or its local representative or use the RAN procedure in the
chapter "S
ERVICE
&
M
AINTENANCE
", section "Product Return".
Useful tips
Cleaning
The painting of the CineMonitorHD is resistant to general cleaners and solvents. Do not use abrasive
products to clean your product.
The front glass is a high quality optical part. A metallic multi-layers vacuum deposit makes the anti-
reflection coating. Do not use abrasive or acid cleaners. The microfiber cloth delivered with the
CineMonitorHD is strongly recommended to clean the glass. Remove dust and particles of the glass
before using the cloth. No liquid is normally necessary. If there is some dirt on the screen, it is
possible to remove it with clean warm water.
The microfiber cloth collects grease particle in its structure. It is necessary to wash it when necessary
with water and soap.
The microfiber cloth is orderable as spare part (refer to your local Transvideo dealer in case of need).
Full reset
If needed, a full reset of the monitor may be performed as follows:
①
Connect the monitor to a power source (monitor off).
②
Press the adjust (ADJ) key
③
Switch on the monitor while keeping pressed the “adjust” key until the display shows “FULL
RESET”
The monitor is back to its factory default settings. This procedure totally erases all user setup in the
memories.
