M
ENU
F
UNCTIONS
Operator Manual Rev 1.1
Page 31
3D
This menu is visible when WIRELESS 3D input is selected.
IMPORTANT:
In the following description we assume that the left eye camera is always wired on SDI1 or
HDMI1 (IN1) on the transmitter, and the right eye camera on SDI2 or HDMI2 (IN2).
DEROBE’S GRID
The Derobe’s grid is mainly used to adjust infinity parallax to the target screen size. It is a parallel grid
with adjustable width between the lines.
In zoom mode the grid is sized to the native resolution.
When SAFE AREA is active, the grid appears only in the safe area (eventually resized depending of
the settings).
About Derobe's Grid:
The grid is a specific tool for stereographic work that has been developed in cooperation with
Alain Derobe, AFC. Alain Derobe was a french stereographer and 3D consultant.
GRID: ON/OFF
Activates or deactivates the grid. It can also be activated directly through the Marker key.
WIDTH
Adjusts the separation between the vertical lines from 6 to 122 pixels. Corresponding value in % is
also given. The number of corresponds to the incident picture pixels, not to the screen pixels (except
in ZOOM mode in which the picture is displayed in full resolution, pixel to pixel)..
OFFSET
Shifts the grid left or right of half of the WIDTH value.
COLOR
Sets the color of the grid
AREA
Displays a safe area on the center of the grid in order to only see the picture. From 100% where the
picture is fully covered to 5% where only the borders are covered.
INTENSITY
Sets the brightness of the grid
DENSITY
Sets the density of the lines from dots to solid.
