EO2P User Guide |Page 46
33706 Rev. A
Status LEDs
The EO2Pxx4052-111 provides multiple LEDs for status and diagnostics of the Ethernet,
Cat 3/Cat5 and POE functions. Use the status LEDs to monitor EO2Pxx4052-111 operation
in the network.
Local PSE Unit Remote PD Unit
PWR
: Power and bootloader status:
Power applied:
Green
- ON
Firmware update in progress:
Orange
– ON and/or BLINK
COPP:
2 Wire Power delivery (local) or sourcing (remote) status and/or fault:
EO2PSE4052-111 (Local PSE unit)
Classification
: Hunting for remote
Green – BLINK
Classification
fault
: Classification error, restarting detection
Red – ON/BLINK
Power
applied
: 57VDC Power over
2-wire
enabled
Green – ON
Classification
: Remote unit sourcing power from external PS
Green –
Blink
EO2PSE4052-110 (Remote PD unit)
Power from 2-wire status
Sourcing power from 2-wire
Green
– ON
Sourcing power from external PS
Green
– BLINK
If the external power supply (4-pin DIN or 2-Pin Terminal block) is present this will
be used in favor of the 2-wire power.
If the external power is lost, the unit will briefly power down and then start
sourcing from the 2-wire.
If the external power is then re-established, the device will switch back without
interruption to the external power.
IEEE 802.3af/at port POE delivery
Red
– BLINK
Cannot maintain RJ-45 POE power delivery
Indicates that the
2-wire
power loss is too great to maintain the requested power
from the IEEE 802.3af/at RJ-45 POE-PSE port
DATA
: 2-Wire data link
Linked:
Green
– BLINK
SECURITY
: Secure mode, pairing mode, and key/config state:
Not secure:
OFF
Secure:
Green
– ON
In Config mode:
Green
– Slow BLINK
In Pairing mode:
Green
– Fast BLINK
Received key & finished config:
Green
– 3 BLINKS
