EO2P User Guide |Page 44
33706 Rev. A
Back Panel RESET Button Functions
The EO2P back panel
RESET
button is used for other functions besides Pairing / Unpairing
the units for secure (encrypted) 2 Wire network operation. You press and hold the
RESET
button for different periods of time to perform different functions; the LEDs blink at
different rates to indicate the function selected.
Press and hold the
RESET
button on the back panel for:
□
1-10
seconds to reset / reboot the device. Blink rate is medium (on = off).
□
10-20
seconds to start Pairing. Blink rate is Slow (long on then short off). See next section.
□
20-30
seconds to unpair security. Blink rate is Fast (long on then short off).
□
30-40
seconds to do a Factory Reset (reset to factory default settings). Blink rate is long on and
then long off.
□
> 40
second: if you press and hold the back panel
RESET
button for over 40 seconds, nothing
happens when you release the
RESET
button.
Note
:
1.
Re-boot at the end of security Pairing, even if cancelled or stopped part way.
2.
Re-boot both units if security pairing was started and completed.
3.
If you started just one unit, just re-boot that one unit.
4.
The
SECURITY
LED lights on both units when Paired successfully.
Summary of RESET Button Functions
Function
to perform
Press and hold
RESET
for:
LED blink rate
Reset / reboot the device
1-10
seconds
Medium (on = off)
Start security Pairing
10-20
seconds
Slow (long on then short off)
Unpair security
20-30
second
Fast (short on then long off)
Factory Reset (reset to
factory defaults)
30-40
second
Long on and then long off
Security Pairing and Unpairing via the
RESET
button is described in the following section.
