Toro Workman 3000 Series, Service Manual

Page: 126 / 306

Power Take–Off (P.T.O.) Service
34
35
18 to 22 ft–lb
(24.5 to 29.5 N–m)
11
5
1
4
23
22
9
6
7
8
17
3
19
20
21
13
14
2
12
2
3
3
32
33
31
30
29
27
28
26
25
24
17
17
10
11
16 15
18
Figure 115
1. PTO cover 13. Shift collar 25. Intermediate shaft
2. Cap screw (4 used) 14. Gear (29T) 26. Gear (37T)
3. Lock washer (7 used) 15. Bushing 27. Retaining ring
4. Cap screw (3 used) 16. Thrust washer 28. Retaining ring
5. O–ring 17. Bearing 29. Thrust washer
6. Shift arm 18. Retaining ring 30. Bearing
7. Shifter block 19. Shift lever 31. Oil seal
8. Spring 20. Spring pin 32. Output shaft
9. Ball 21. Spring pin 33. Stud
10. Retaining ring 22. Alignment pin (2 used) 34. Lock washer
11. Bearing 23. PTO housing 35. Hex nut
12. Input shaft 24. Gear (27T)
Disassembly (Fig. 115)
NOTE: Item numbers in figures are shown in order of
disassembly; for example, remove Item 1 first, then Item
2, etc. Reassemble in reverse order; for example, install
Item 1 last.
1. Put vehicle on a level surface. Stop the engine and
remove key from ignition switch. Remove the bed or oth-
er attachment(s). Allow engine and radiator to cool.
2. Remove PTO from top of transaxle (see PTO Re-
moval and Installation in this chapter).
3. Thoroughly clean outside surface of PTO case.
Figure 116
4. Loosen cap screws and nut. Note location and length
of cap screws. Separate PTO cover from PTO housing.
Drive Train
Page 6 – 54
Workman 3000/4000 Series