Toro Workman 3000 Series, Service Manual

Page: 190 / 306

Workman 3000/4000 Series Page 8 – 20 Electrical System
Headlight Replacement
Disassemble and assemble headlight as follows:
1. Set parking brake, turn ignition off, and remove key.
2. Reach beneath dash and disconnect the wiring har-
ness connector from the headlight.
3. From beneath the dash, push headlight out of the
hood.
4. Remove rubber seal from around the headlight. Dis-
card headlight.
5. Align notch on the inside of the seal with the notch on
the new headlight. Slide seal onto the headlight until the
seal is firmly in place.
NOTE: Applying soapy water to the outside of the seal
will aid in sliding the seal into the hood. Make sure to
thoroughly dry headlights before turning lights on.
6. Align notch on the outside of the seal with the notch
in the hood. Push headlight and seal into the hood until
it is firmly in place.
7. Connect the wiring harness connector to the head-
light.
1. Front hood
2. Headlight
3. Headlight mount
Figure 25
2
1
3
Tail Lamp Replacement
Disassemble and assemble tail lamp using Fig. 26 as a
guide.
The tail lamp uses a standard #1157 12volt bulb.
1. Screw (2 used)
2. Lens 3. Bulb
4. Gasket
Figure 26
1
2
3
4