Toro Workman 3000 Series, Service Manual

Page: 169 / 306

Workman 3000/4000 Series Page 7 – 33 Chassis
Removal (Fig. 27)
1. Park vehicle on a level surface, raise and support
bed (if installed), shut engine off and engage the parking
brake.
2. Remove ROPS from vehicle (Fig. 28)
3. Remove knobs from control levers, then remove
center console control plate assembly.
4. Remove four (4) socket head screws that secure
each seat to vehicle. Lift both seats from vehicle.
5. Remove cap screw, flat washer and lock nut that se-
cure each front corner of seat base to frame.
6. Disconnect radiator overflow tank hose at radiator
and plug the hose.
7. Carefully lift seat base from vehicle.
Installation (Fig. 27)
1. Position and secure seats and seat base to vehicle
with removed fasteners.
2. Reconnect radiator overflow tank hose to radiator.
3. Secure center console control plate to vehicle. Install
knobs on control levers.
4. Install ROPS to vehicle with four (4) cap screws and
flange nuts (Fig. 28).
Figure 28
1. ROPS frame
2. Cap screw (4 used)
3. LH ROPS receiver
4. Flange nut (4 used)
5. RH ROPS receiver
1
2
3
5
4
Chassis